P1106 – Audi DTC

Audi DTC P1106 – O2 Sensor Circuit, Bank2-Sensor1 Voltage too Low/Air Leak

DTC P1106 meaning on Audi

DTC P1106 on an Audi indicates an issue with the O2 sensor circuit for Bank 2, Sensor 1. This fault code specifically points to a low voltage condition or an air leak in the system. The O2 sensor is responsible for monitoring the oxygen levels in the exhaust gases and providing feedback to the engine control module (ECM) for proper fuel mixture adjustments.

Audi DTC P1106 symptoms

Symptoms of DTC P1106 on an Audi may include:

• Check Engine Light (CEL) illuminated on the dashboard
• Poor fuel economy
• Rough idling or stalling
• Lack of power or acceleration

Audi DTC P1106 causes

Common causes of DTC P1106 on an Audi include:

• Failed O2 sensor (Bank 2, Sensor 1)
• Wiring or connector issues in the O2 sensor circuit
• Vacuum leaks or air intake leaks
• Exhaust system leaks

Audi DTC P1106 seriousness

DTC P1106 should not be ignored as it can lead to poor engine performance and increased emissions. Driving with a faulty O2 sensor can also cause damage to other components in the vehicle over time. It is recommended to address this issue promptly.

How to diagnose DTC P1106 on Audi

To diagnose DTC P1106 on an Audi, you can follow these steps:

1. Use an OBD-II scanner to retrieve the fault code and check for any additional codes.
2. Inspect the wiring and connectors related to the Bank 2, Sensor 1 O2 sensor for any damage or corrosion.
3. Perform a visual inspection of the exhaust system for leaks or damage.
4. Check for vacuum leaks or air intake leaks that could affect the O2 sensor readings.

How to fix DTC P1106 on Audi

To fix DTC P1106 on an Audi, you can try the following solutions:

1. Replace the Bank 2, Sensor 1 O2 sensor if it is faulty.
2. Repair any damaged wiring or connectors in the O2 sensor circuit.
3. Address any vacuum leaks or air intake leaks in the system.
4. Fix any exhaust system leaks that may be affecting sensor readings.

How to erase DTC P1106 on Audi

To erase DTC P1106 on an Audi, you can use an OBD-II scanner to clear the fault code from the ECM’s memory. After addressing the underlying issue causing the fault code, you can reset the CEL and monitor the vehicle for any recurring problems.

Recommended tools for Audi diagnostics

Explore our expert picks: The Best OBD2 Scanners for 2025

Easy-to-use Multimeter for reliable diagnostics: AstroAI Auto-ranging Multimeter

Some of the links on this page may be affiliate links, which means we may earn a small commission if you make a purchase. This helps us keep our DTC database up to date and provide valuable content for free. We only recommend products that we have tested and believe to be the best in their class.