P1367 – Acura DTC

Acura DTC P1367 – TDC 2 Sensor No Signal

DTC P1367 meaning on Acura

DTC P1367 on an Acura indicates that the TDC 2 Sensor is not sending a signal to the Engine Control Module (ECM). The TDC (Top Dead Center) sensor is crucial for determining the position of the crankshaft in relation to the top dead center position of the piston. This information is vital for the ECM to accurately control ignition timing and fuel injection.

Acura DTC P1367 symptoms

Symptoms of DTC P1367 on an Acura may include:

• Check Engine Light illuminated
• Engine misfires
• Engine may not start
• Decreased fuel efficiency
• Engine may run rough

Acura DTC P1367 causes

Common causes of DTC P1367 on an Acura include:

• Defective TDC 2 Sensor
• Wiring or connector issues in the TDC 2 Sensor circuit
• ECM software or hardware problems

Acura DTC P1367 seriousness

DTC P1367 should be addressed promptly as it can lead to drivability issues and potential engine damage if left unresolved. Ignoring this code may result in poor engine performance and increased emissions.

How to diagnose DTC P1367 on Acura

To diagnose DTC P1367 on an Acura, follow these steps:

1. Use an OBD-II scanner to retrieve the fault code and freeze frame data.
2. Inspect the TDC 2 Sensor and its wiring for any visible damage or corrosion.
3. Check the TDC 2 Sensor signal using a multimeter to ensure it is within specifications.
4. Perform a continuity test on the sensor circuit to check for any open or short circuits.

How to fix DTC P1367 on Acura

To fix DTC P1367 on an Acura, consider the following steps:

1. Replace the TDC 2 Sensor if it is found to be faulty.
2. Repair any damaged wiring or connectors in the TDC 2 Sensor circuit.
3. Clear the fault code using an OBD-II scanner after making the necessary repairs.
4. If the issue persists, further diagnosis may be required to address underlying ECM problems.

How to erase DTC P1367 on Acura

To erase DTC P1367 on an Acura:

1. Connect an OBD-II scanner to the vehicle’s diagnostic port.
2. Access the scanner’s menu to clear the fault codes stored in the ECM.
3. Follow the on-screen prompts to erase the DTC P1367 code.
4. Ensure the repair has been completed before clearing the code to prevent it from reoccurring.

Recommended tools for Acura diagnostics

Explore our expert picks: The Best OBD2 Scanners for 2025

Easy-to-use Multimeter for reliable diagnostics: AstroAI Auto-ranging Multimeter

Some of the links on this page may be affiliate links, which means we may earn a small commission if you make a purchase. This helps us keep our DTC database up to date and provide valuable content for free. We only recommend products that we have tested and believe to be the best in their class.